Encoder 629906-16 62V22-02-040C for GE PRO1000 Patient Monitor Spare Part Used

Encoder 629906-16 62V22-02-040C for GE PRO1000 Patient Monitor spare part

► Brief Description

The encoder, part number 629906-16 62V22-02-040C, is compatible with the GE PRO1000 Patient Monitor and is primarily responsible for menu navigation, parameter adjustment, and waveform selection. The encoder boasts a rotational lifespan of over 1 million cycles, ensuring a long service life for monitors that require frequent parameter settings. With 16 positioning points and a unique torque design, the encoder offers a smooth and moderately damped operation, preventing accidental presses due to excessive looseness or operational inefficiency due to excessive tightness.

► Specifications

►Detailed Photos

►Encoder Installation Steps

1. Preparation Before Disassembly

Be sure to disconnect the monitor from the AC power supply and remove the built-in battery pack to ensure the device is completely powered off.

Wear an anti-static wrist strap or touch a metal object before operation to prevent static electricity from damaging the motherboard circuitry.

2. Removing the Front Panel and Motherboard

Use a suitable screwdriver to remove the screws securing the back and bottom of the device. When opening the back cover or separating the front panel, be careful with the flexible ribbon cables connecting the display and the keypad. Disconnect these cables carefully to avoid tearing.

3. Replacing the Encoder Assembly (629906-16)

This encoder is usually soldered or plugged into the keypad control board, located at the knob position on the side of the display. Check if the encoder is secured to the housing with a nut. If so, first remove the external securing nut with pliers or a socket wrench, then directly pull out the old assembly and insert the new assembly, aligning it with the notch.

4. Reassembly and Testing

When installing the new encoder, ensure its positioning posts are aligned with the holes on the circuit board to avoid twisting.

Before fully tightening the casing screws, it is recommended to connect the battery and test the device. Rotate the encoder to observe whether the menu selection or numerical adjustment on the screen is responsive, and press the knob to confirm whether the functions are working properly.

After confirming that the functions are working correctly, disconnect the power, tidy up the internal cables, close the casing, and tighten all screws evenly.

►FAQ

Q1: Is the encoder original?

A1:Yes, it’s original, and removed from the original patient monitor

Q2:How long is the warranty for the product

A2:It has 90 days warranty.

Q3:How long will it take to receive it?

It’s about 3-5 working days

Thank you for your attention, if you want to know more details about the Encoder 629906-16 62V22-02-040C for GE PRO1000 Patient Monitor, please feel free to contact me . Looking forward to your early inquiry.